DuraSeal Quick Dry Sealer – 1 qt.

This product provides a firm bond between the wood floor substrate and succeeding finish coats, and meets the definition for a quick dry sealer by method ASTM D 1640.

Surface preparation

1. Sand floors according to NWFA specifications.
2. Vacuum thoroughly and tack the floor. If desired, apply DuraSeal penetrating finish in your choice of color and allow to dry thoroughly, per label directions.

Application

1. Apply DuraSeal quick dry sealer with a natural China bristle brush or lambs wool applicator at a coverage rate of 500 square feet per gallon.
2. Allow surface to dry thoroughly (e.g. 1-1/2 to 2 hours.)
   Note: drying time will be increased by high humidity, low temperature, lack of air movement or heavier application.
3. Buff surface with a new 180 grit screen or used 150 grit screen; vacuum thoroughly and tack.
4. Apply the appropriate number of DuraSeal polyurethane finish coats to achieve the desired look or durability.

Specifications

• Storage: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame.
• Solvent: Mineral spirits
• Physical properties
• Density (lbs/gal): 0.85 – 0.87
• % solids: 39.50 – 41.50
• Viscosity – cps: less than 100 cps.
• VOC (b/l): 525 max.
• Flash point: 103°

Technical

Product Data Sheet | Safety Data Sheet